# PCBV2 Switch wiring issues

**URL:** <https://discourse.agopengps.com/t/pcbv2-switch-wiring-issues/7766>\
**Category:** PCB\
**Created:** [11 December 2021 12:37 UTC](https://discourse.agopengps.com/t/pcbv2-switch-wiring-issues/7766 "2021-12-11T12:37:24Z")\
**Posts on this page:** 4\
**Page:** 2

<div class="post-metadata">

**Author:** ![Pat](https://discourse.agopengps.com/letter_avatar_proxy/v4/letter/p/8491ac/32.png) [@Pat](https://discourse.agopengps.com/u/Pat)\
**Post date:** [13 April 2023 02:36 UTC](https://discourse.agopengps.com/t/pcbv2-switch-wiring-issues/7766/21 "2023-04-13T02:36:20Z")

</div>

If you have selected pressure or current switch be sure that the cut off value is high enough, above the reading.

---

<div class="post-metadata">

**Author:** ![Stuart](https://discourse.agopengps.com/letter_avatar_proxy/v4/letter/s/cab0a1/32.png) [@Stuart](https://discourse.agopengps.com/u/Stuart)\
**Post date:** [13 April 2023 07:26 UTC](https://discourse.agopengps.com/t/pcbv2-switch-wiring-issues/7766/22 "2023-04-13T07:26:51Z")

</div>

It’s just a momentary push switch

---

<div class="post-metadata">

**Author:** ![Stuart](https://discourse.agopengps.com/letter_avatar_proxy/v4/letter/s/cab0a1/32.png) [@Stuart](https://discourse.agopengps.com/u/Stuart)\
**Post date:** [13 April 2023 07:37 UTC](https://discourse.agopengps.com/t/pcbv2-switch-wiring-issues/7766/23 "2023-04-13T07:37:55Z")

</div>

When I have selected either button or switch in the steer settings config and sent it to the module, I was expecting the icon to turn yellow immediately? Only after if there was a fault in my wring or swtch then it might just not turn green?

---

<div class="post-metadata">

**Author:** ![Stuart](https://discourse.agopengps.com/letter_avatar_proxy/v4/letter/s/cab0a1/32.png) [@Stuart](https://discourse.agopengps.com/u/Stuart)\
**Post date:** [13 April 2023 08:09 UTC](https://discourse.agopengps.com/t/pcbv2-switch-wiring-issues/7766/24 "2023-04-13T08:09:41Z")

</div>

What should normal operation be? I have it cycling between yellow and red by pressing my button or switch.

PROBLEM SOLVED.

[Previous page](https://discourse.agopengps.com/t/pcbv2-switch-wiring-issues/7766.md?page=1)