Trimble valve for AOG

Hardware Hydraulic Systems

Larsvest 28 January 2025 19:01 2

Welcome to the forum
Maybe this thread is of interest.

Wiring for Eaton vickers valves on NH 8970 Hydraulic Systems

Hi Folks I have an eaton vickers valve like this one MCD-8632 EATON - VICKERS For Sale in Fort Dodge, Iowa | shop.thegatorcenter.com The solenoids (the two brass looking nuts are on top of these) are just isolation for when autosteer is not in use. I am using a nano board, MD13S cytron board to drive the motors, an ADS1115 analog digital convertor from the wheel angle sensor, and a single channel relay to control power to the solenoids. From the nano the signal to open the solenoids comes from …

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled