Has anyone any experience of fitting an electric motor to drive an Accord metering system to replace the land wheel.
I will use an RC11 rate control PCB to control the motor, so that side is covered and no problem, wondering if anyone has motor recommendations?
I think I need a motor that will do 20-70RPM with approx. 7Nm of torque, any ideas of a motor that fits the bill.
Hman
2
This is an Australian site, but will give you an idea of wattages and torque to start searching locally.
BrianP
3
Our newish Amazone has this type now.
It may need to be slower than 20rpm.
I’ve seen this one lower on small seed low rates.
1 Like
nrwj
4
Have you looked at the specifications of the frontier reto kit for grain drills
