Thanks I will try that.
Hi Kaupoi,
Yes I stand corrected you are right you don’t need to use AOG it works perfectly fine from f9p straight into SNIP. Thankyou for your help.
I got this wrong, you can eliminate AOG and feed f9p straight into SNIP. Kaupoi put me right on this.
Can anyone tell me if I did anything? F9P + Xbee WiFi Ntrip, configured to connect to home WiFi, but it seems to me it is not.
If you have wifi NTRIP MASTER connect to home network and setup a NTRIP server and you can directly transmit to rtk2go no need for additional tools.
1 Like
I also tried this.
What version is that of softwere maybe try latest 0.5.4 it show how many B/s you are transmitting in and out and have network forwarding. Switch to UART 0, IP to DHCP.
Better question is what base config you use and are messages enabled on UART2.
1 Like
v0.5.2
Did you use ardusimple config for base?
1005: Stationary RTK reference station ARP
1074: GPS MSM4
1084: GLONASS MSM4
1094: GALILEO MSM4
1230: GLONASS code-phase
Check if this messages are enabled on UART2. (CFG-MSG) in u-center. If they are not enable them.
1 Like
I have just upload it from ardusimple
No that one should not be enabled only those 5 needs to be enabled. It seams that you didnt save config.
Follow instructions on ardusimple site when you upload config go to messages to check if only these 5 messages are enabled on UART2. If its all good save config
1 Like
Config as ardusimple instructions and “UBX-CFG-CFG” → Send
Now base is set go back to wifi ntrip master and try connecting, set setting in ntrip master config UART0 and set ip to dhcp try connecting to rtk2go.
1 Like
Change in lights
Ok
Thank you Radmuffins!
1 Like
I am setting up my base station using my ublox F9P feeding into SNIP then to agopengps. I have my registered base station name from RTK2Go. I have followed steps 1-7 and in SNIP set my data format to Auto detect w parse. In SNIP my serial stream is inputing data(I assume from my F9P) butwith no output. My pushed-out stream connection says Data Starved. In Agopengps my MOUNT is not listed and such I cannot connect.
Anyone have any suggestions what might be wrong? I assume it is a setting somewhere.
Perhaps it’s this maybe (part 7 but Data format is Auto Detect w/Parse, and the rest of the settings leave as default.
Edit: “Enable logging” off obviously)Kaupou said this to me but I find logging made no difference.
Its a while since I did this, I will read through and see if I find a reason.
Kevin
Thanks Kevu. I will try these settings.