Im having a problem with my gps.
I’m running a kaupoimod pcb with ardusimple gps and bno compass. Both are run through usb to the panasonic tablet.
As you can see in the picture my gps lines are pretty straigt. But when I turn the gps gets disorientated and when I place the tractor in front of my next pass I have to set driving direction again and center the line. This kinda defeats the purpose of gps. My mapping als shows up all weird.
That will be very difficult for us to believe.
Post all of your settings, and we can proceed from there.
Maybe post your latest vehicle xml file from agopengps folder
Your farmers are not working on King’s day? Most of us don’t have that luxury. Anyway, we were supposed to get additional info on Friday, any festive on Friday?
But i think the problem is not that the implentwith isn’t correct or something. Because when I turn it goes like all crazy and on the screen the tractor is somethimes on the other side of the previous pass as where I am then. So to my believe there is something not right in the gps signal. Also because when you disconnect the steering board, there is no change that the IMU or WAS interver with the gps signal and thereby cause noise on the gps sigal. And it does the gps position jumping not always. It does it 90% of the time, but like 10% of the time it works good. (Not that it works good for a couple of seconds but more like a couple of hours to a day) And in the mean time I haven’t change any of the vehicle settings.
But why do you have an offset of 235 cm?
That will be a huge problem for you, even if you really have the antenna 235 cm to the right of tractor centre!
Edit: learned from telegram that it is still minus when antenna is to the right. Probably because AOG see center as 235 cm to the left of the antenna!
