T8 New Holland

[Larsvest]

@iggy

also have had a harder time finding the pin out diagram at least freely

I see A lot of my OneDrive links are gone.
How much are you able to see on my OneDrive via this link?

AOG on Autosteer ready New Holland T6-175 year 2018

[quote=“Val, post:26, topic:4468”] Yes I have a steer ready tractor The steer diagram in zip file looks to be quite the same than the diagram that I use. So I just need to delete the wire from dump valve to the SRD-05VDC-SL-C (the arduino high level trigger if I well understand). The Arduino type has optocoupler which protects the Nano better. Look further down about wires I also should connect the signal wire from pressure sensor to A0. I think that I always would need…

As you see it is in post 27, but check the links in post 48 as welll