Bit of Christmas tinkering,tidying up my setup.
Found this Hammond enclosure on eBay for just over a tenner.
Just needed shortening by 50 mm.
Found this Hammond enclosure on eBay for just over a tenner.
Just needed shortening by 50 mm.
4 Likes
Looks great, making me wish I went with the micro board now
Yes it makes for a very tidy,compact setup.
Also added the small breakout board to get the RTK signal to my Amatron 3 which worked a treat.
4 Likes
If you change your mind I have a couple of AIO micro boards available.
Unfortunately ive already ordered my a9p, i went with the standard board because of the hammond enclosure and the wildbuckwheat faceplate, its awesome when stuff like this looks like a factory production
I’m sorry if you missed it, but there is a PCB faceplate and Hammond box for both. I’ll edit the git and cross link them so that they are easier to find. The standard box is nice and slim and slips next to seats on the floor nicer, I don’t think you’ll have any regrets.
https://github.com/WildBuckwheat/AIO-Standard-Hammond-Faceplate
https://github.com/WildBuckwheat/AIO-Micro-Hammond-Faceplate
BrianP, the metal faceplate looks great and the DB9 with MAX232 is a great addition. For future versions of the AIO we hope to include the MAX232 adapter on the PCB, or at least have solder pads to make the soldered wire connections easier.
2 Likes
I have choice of both, but have Standard in tractor as fits beside seat nicely, the Micro being slightly wider can be fouled by the air seats bouncing.
You could shorten a Std Hammond enclosure and there will not be much difference.
That’s a great idea,the DB9 connector is very useful and easy to configure.
This looks great and mirrors what I was thinking of doing to output a signal to my drill/fertiliser controllers. Just out of interest, where is the other side of the yellow wire to the MAX 232 connected? I’m assuming it is to the pin for where the second GPS receiver would have gone?
Also, did you have to make any changes to the sketch for the Teensy to output the fused NMEA message?
Apologies if this has already been answered somewhere. I’ve belatedly started thinking about adding a second box to a tractor to do autumn work whilst in the midst of harvest (too much time to think sitting on the combine!) and I’ve run KaupoiMod boards before and am only just thinking about AIO boards!
I can’t quite remember without opening the box but yes the yellow wire goes to the second F9p socket and into rx or tx?
No change to Teensy code but need to configure uart2 to output the right messages in ucentre.
I followed this thread.
You could alternatively use “Gpsout” now which is simpler and connects to the usb on the tablet.
1 Like