Which version number are you using?
Connected by usb or udp?
Looks like you are not updating, the roll sensor looks like it just stays at one value. I had an issue with this freezing last night but it disappeared after a full restart.
V5.4
Connection usb.
IMU works when I move the box with the module, the values change, but the application itself jumps. It is the same with the gps itself. The program in simulator mode works fine and smooth
What do you set baudrate to in usb connection for GPS
In u center 9600 and in AiO, I tried all the bardurate settings.
I don’t remember what speed I chose when installing firmware 1.13 to U blox.
I use 36000, and can’t use lower than that.
If you did set 9600 in f9p you will certainly have the problems you showed in movie.
So where do I need to change? I did as described.
Someone will suggest how to solve the problem?
Try with other cables. Other hub if using one.
As @PotatoFarmer said the problem come from your really bad GPS refresh rate.
Once every 2 sec and very unstable! 
Also update to v5.5 ou v5.6.
But i think the link only lead to U-blox and how to update firmware.
Did you get all the green dots when updating firmware to ver 1.13 (can’t be done at 9600 baudrate speed) I think minimum is 115000
Did you then try to upload the Rover setup file for version 1.13 which will give you 8 or 10 Hz update rate.?
1 Like
No, about 70% were green and the rest were blue.
I trying many other cables… With and without hub. On laptop and on tablet. Trying version 5.5.
I did firmware updates on 115000 now, but that didn’t help either. Where can I check the refresh rate?
The refresh rate should be shown at very top right next to quality fix.
If you connect your GPS to U-center the data(position, satellites) update really fast? You should see the data updating many times per second.
Probably not, it works slowly. I will record and upload a movie.
70 % is OK firmware done correct 
What firmware number 1.13 or 1.30?
Did you then upload rover 1.13 again?
Firmware update reset f9p to standard (UBX and 1 Hz as far as I remember)
I don´t think you can use rover 1.13 on firmware 1.30
Firmware 1.13. Yes, I have uploaded the roverortner again.
1 Like
certainly look 1 Hz.
I do not have U-center here, someone else help him by saving the configuration!
And speed up to something faster than 9600
I do it this way and it doesn’t change anything.
After uploading the roverortner, the speed changes by itself to 9600. How to change it?
unplug F9p and replug it
It’s the same and every time the bardurate shows 9600