Yes that is right.
Swapping RX and TX has no effect. and I’m hooked to pins 7 & 8 - RX2 - TX2.
I figure I should be configured as described in the Sketch.
// Configuration of receiver
// Position F9P
// CFG-RATE-MEAS - 100 ms -> 10 Hz
// CFG-UART1-BAUDRATE 115200
// Serial 1 In - RTCM (Correction Data from AOG)
// Serial 1 Out - NMEA GGA
// CFG-UART2-BAUDRATE 460800
// Serial 2 Out - RTCM 1074,1084,1094,1230,4072.0 (Correction data for Heading F9P, Moving Base)
// 1124 is not needed (China’s BeiDou system) - Save F9P brain power
Here is what I have
The RTCM messages are greyed out & I haven’t figured out how to select them. I’m Also not sure of how to set -
Serial 1 In - RTCM (Correction Data from AOG)
Serial 1 Out - - NMEA GGA