Yes I was able to read it using SavvyCAN on a NH T7.235.
Here is a decoding of the handle in the picture below:
Message ID: 18FFB306
0x03 to 0x13 (byte 2) bit 20 go to 1 for button on back
0x03 to 0x13 (byte 6) bit 52 got to 1 for down shift
0x03 to 0x07 (byte 6) bit 50 goes to 1 for up shift
0x3F to 0x7F (byte 4) bit 38 goes to 1 for backward direction
0XFC to 0xFD (byte 5) bit 40 goes to 1 for forward direction
0x03 to 0x07 (byte 2) bit 18 & 0x03 to 0x43 (byte 6) bit 54 for the auto button
Message ID: 18FFB406
0x03 to 0x07 (byte 5) bit 42 goes to 1 for autotrak button
0x03 to 0x07 (byte 1) bit 10 goes to 1 for rear hitch up
0x03 to 0x13 (byte 1) bit 12 goes to 1 for rear hitch down
0x03 to 0x43 (byte 1) bit 14 goes to 1 for turn around
Message ID: 18FFB606
0x02 to 0x42 (byte 3) bit 30 goes to 1 for left on d-pad
0x02 to 0x12 (byte 3) bit 20 does to 1 for right d-pad
0x02 to 0x12 (byte 1) bit 12 goes to 1 for up d-pad
0x02 to 0x42 (byte 1) bit 14 goes to 1 for down d-pad
