All in One PCB

Hi Jesse! Thank you for your help!

What do you mean about router Wifi? I pluged in my teblet to router using my cable and it works fine. I didn’t mentioned that i use a tablet with type c to ethernet doungle.

The soldering on the ethernet socket looks good. And I checked the connections with a multymeter. It seems that everything is fine, but I’m not sure.

You’re aware of the board to board small connector between the PCB and teensy right?
https://www.digikey.fr/fr/products/detail/gct/BF050-06-A-B-0400-0300-L-G/16396911

Yes I am! I also checked if they are connected. Maybe I dameged the ethernet chip during soldering?

how hot does your solder get?

380 degrees celcium, but i tried to do everything fast. Or I was wrong?

I stil can’t conect with udp, but USB works!

I see that in AIO antena now lights green but imu is not. But the data at the top left corner are present for imu. Should I bother?
What are the proper baud rates for antenna, imu and steering?



Try it on a desktop PC, so you can eliminate the USB/ethernet adpater.

You do not need 12V for testing on a PC with Standard AIO (you do for the Micro AIO), just plug USB into Teensy for power, Power/Ethernet led should turn green as soon as you plug Ethernet cable in.

Have you updated firmware on F9P and config file?

I tried to connect with my pc and it doesn’t see it. I probably did fry something. I’ll try with another Teensy when I get one. I’m really curious!

Yes I updated F9P and configed it.

I’m going to use the AOG with 24V motor. The planting is soon, so I’ll probably use it with USB. In this case I shouldn’'t put 12 v to the board throug AMPSEAL? Is it safe to put 24V to the clamp on the board?

Yes safe to put 24v to the screw terminal, that power only travels through the Cytron.

1 Like

Thank you!

Does the output from Cytron goes to AMPSEAl?

Yes Cytron outputs through Ampseal pins 5 and 6.

Hi, would you show me how you solved the additional pcb cable going from the amp to 12v? I will be installing a 12v engine and would like to make sure nothing serious happens. This is my PCB😁

Direct 12V in (black)
Direct left/right out (brown)

Current board only good up to 3A (the ampmeter can do 5A)

This way we directly power up the cytron. And have no problem using it with the MFA motor that can pull 5-7 amperes.

I was told the newer board will be able to handle 7-10 amps :slight_smile:

2 Likes


Hi guys, what am i missing? should i wait or order?

If you can wait a little while to order: there are some boards with an updated design being shipped for testing right now. The updated design should be released soon.

3 Likes

What could be wrong, the steer doesn’t work? Another similar AIO pcb works on the same tractor.



IMG_20230330_182421

Is anyone using the XBee radios on the Simple F9P modules with V2.4? Curious about any nuances or complications.

No was.
Why do you have a ads1115 on the board? Was there not a a/d smd chip on the board under the ads1115?

I have measured all was circuits on pcb. Traktor’s was works on another circuit board. There is no smd chip, I have soldered all the footed components myself.

Check the teensy by serial monitor (via USB), may be the ADS is not detected for any reason.

1 Like